Current Electricity and Electrical InstrumentHard
Question
A diode detector is used to detect an amplitude modulated wave of 60% modulation by using a condenser of capacity 250 pico farad in parallel with a load resistance 100 kilo ohm. Find the maximum modulated frequency which could be detected by it.
Options
A.10.62 MHz
B.10.62 kHz
C.5.31 MHz
D.5.31 kHz
Solution
For low pass filter, frequency greater than 
can′t pass trhough filter
⇒ f <
⇒ f < 
= 4 × 104 Hz
= 40 KHz
in given options maximum frequency below 40 KHz is 10.62 KHz
can′t pass trhough filter⇒ f <
⇒ f < = 4 × 104 Hz = 40 KHz
in given options maximum frequency below 40 KHz is 10.62 KHz
Create a free account to view solution
View Solution FreeTopic: Current Electricity and Electrical Instrument·Practice all Current Electricity and Electrical Instrument questions
More Current Electricity and Electrical Instrument Questions
The reading of voltmeter is...A resistance of 2 Ω is connected across one gap of a metre-bridge (the length of the wire is 100 cm) and an unknown...In the circuit shown in the figure, if the potential at point A is taken to be zero, the potential at point B is...The area of the plates of the capacitor shown in figure is S. The dielectric constant and resistivity of the material of...n identical cells are joined in series with its two cells A and B in the loop with reversed polarities. EMF of each cell...